AGM AGP 2300 S, Original Instruction Manual

Page: 27 / 71

10
AGM AGP 2300 S (EN)
AC overioad cut out
IMPORTANT: Exceeding the rated capacity of your generator can result in serious
damage to you generator and connected apparatus.
1. Each receptacle has a circuit breaker to protect the generator from over
loading.
2. If the circuit breaker trips, unplug all electrical apparatus from the generator.
3. Let the overload cut out switch cool down.
4. If it is an AC apparatus causing the overload push the AC circuit breaker button.
Commence to start your generator accordingly.
5. When re-connecting appliances, reduce the load to that which previously
overloaded the generator.
DC application
1.
DC terminals are only for charging 12 V battery.
2. Set the switch at “OFF” position while charging. Do not use DC12 V and AC at
the same time.
3. Do not connect the positive pole of the DC terminal with its negative pole,
otherwise the generator damage will result.
4. Connect the positive and negative poles of the battery with the positive and
negative poles of DC terminals separately. Do not confuse them, otherwise the
battery and generator will burn out.
Caution:
1.
To prevent from creating a spark near the battery, always connect the
charging cables to the battery first and only then to the generator. When
disconnecting, you should disconnect the cables at the generator first.
2. Stop charging if the electrolyte temperature exceed 45°C.
Stop the generator
1.
Switch off the AC breaker.
2. Turn the engine switch to the “stop” position .
3. Turn the fuel switch anticlockwise to the “off” position“.
Note: If you want to stop the engine in emergency, please set the engine switch
on “OFF” position“.