AGM 520 E, Original User Manual

Page: 45 / 117

16
AGM 520 E (GB)
WARNING DANGER
The proper shield, which protects you from debris, must be in its place on the
device while you are using the cutting line (picture). The cutting line may
flutter around if there is too much line being fed. Always use the plastic
debris shield with the small cutting blade when using the line head.
WARNING DANGER
Tilting the line head the wrong way will throw the debris TOWARDS you. If
the line head is held flatly relative to ground, so that the cutting is performed
on the entire circular line, the debris will be thrown TOWARDS you, the load
will slow down the engine, and you will use more string.
WARNING DANGER
Use only good quality single-thread cutting line with the diameter of 2.5 mm.
Never use wire or wired thread (string with wire) instead of line. Put only the
line with the prescribed diameter into the line head.
WARNING DANGER
Be particularly careful when you are working on bare or gravel surfaces
because the line may throw the stones at great speed. The shield on the
device cannot stop objects that bounce off or ricochet off hard surfaces.
For nearly all mowing, it is good to tilt the line head so that the contact is made in
that part of the circle line where the line is moving away from you and form the
debris shield (see the picture). It enables the litter (debris) to be thrown away from
you.