AGM Global Vision
16
2. Insert the reducing ring to the grooves and then turn it clockwise as far as it
will go.
3. Rotate the Rattler’s fixing ring (B) clockwise to tighten it on the reducing ring
thread. Please note the fixing ring has left-hand thread. Be careful not to
overtighten the fixing ring.
4. Screw the front adapter (C) into the reducing ring.
NOTE:
Different models of front adapters may have different designs. Refer to the
user manual for your adapter for correct installation.
Install the Rattler TC on the lens of a day scope as follows (refer to Figure 2-7):
1. Turn the lever (A) of adapter (B) backwards to loosen the adapter clamping
device.
2. Slide the Rattler TC with the adapter onto the lens of the day scope (C) as far
as it goes.
3. Affix the clip-on to the day scope by locking the lever (A) of adapter.
4. Rotate the clip-on to align its vertical position. Tighten the lock nut (D) tightly
with the special wrench to secure the position.
5. Verify that the clip-on is firmly secured to the day scope.
NOTE:
AGM recommends that you use an eyecup on the day scope’s eyepiece for
maximum safety and comfort, as well as to escape detection.
2.1.16 INSTALLING THE RATTLER ON A PICATINNY/WEAVER RAIL
Use the optional quick release mount (QR mount) to install the Rattler TC on
a Picatinny/Weaver rail. The mount can be attached to the scope with two
screws (Figure 2-8).
FIGURE 2-7. CLIP-ON INSTALLATION
LOCK
LOCK
D
C
B
UNLOCK
ALIGN
A
