30
AGM Global Vision
2. Slip the neck pad strap all the way under the upper strap retention tab; pull the lower part of the
neck pad strap under the lower strap retention tab.
3. If necessary, repeat steps 1 and 2 for the other side of the headband and neck band.
C. Lacing the Sliding Bar Buckles.
When putting on or adjusting the head mount, the strap may slip
out of the slide fastener. To adjust the strap and sliding bar buckle:
1. Thread the strap from the inside of the buckle over the moveable sliding bar (Figure 3-2). Thread
the strap back through the buckle; this time, thread it under the moveable sliding bar and over
the serrated part of the buckle.
2. Pull the strap through the buckle and tighten.
3. Repeat steps 1 and 2 for any other straps and buckles that have come undone.
3.1.3 NECK CORD MAINTENANCE
The neck cord (Figure 1-2) may be broken or frayed, or the ends may come untied.
If loose, re-tie the ends of the cord. If broken or severely frayed, install a new cord as follows:
1. From the rear, insert the ends of the cord through the holes in the monocular.
2. Thread the end of the right cord through the hole in the objective lens cap.
3. Tie a knot at each end of the cord.
3.2 TROUBLESHOOTING
Table 3-1 common malfunctions that may occur with your equipment. Perform the tests,
inspections, and corrective actions in the order listed.
This table does not list all the malfunctions that may occur with your device, nor does it include all
tests, inspections, or corrective actions that may be necessary to correct them. If you identify an
equipment malfunction that is not listed, or the suggested corrective actions do not correct the
issue, please contact Customer Support.
FIXED
SERRATED
BAR
MOVEABLE
SLIDING BAR
FIGURE 3-2. LACING THE SLIDING BAR BUCKLES
