AGL Encore Maxim, Operator'S Manual

Page: 9 / 73

Operation
4-3
Left Front Control Panel
The left front control panel looks like the figure below.
Figure 2. Left Front Control Panel
Cooling Fans:
Your machine is equipped with lower cooling fans, the rocker switch will turn the cooling fans on and off.
When the fans are turned on, the rocker switch will illuminate. An upper cooling station is available.
Heat Controls:
To use the heat control, simply press the rocker switch to the on position. The only other setting the
operator must change is the set point. To do this press and hold the star button and press the up or down
arrow to adjust the setting. The led in the upper left of the control will illuminate and flash if controller is
heating the coil up. The controller also has a built in overtemp alarm system to protect the rollers from
overheating and destroying the roll coverings. If the roller temperature exceeds the factory preset value,
the machine will go into an emergency stop mode and stop the machine. After the rolls have cooled
down, the operator may attempt to restart the machine by pressing and holding the reset button on the
right rear of the machine. If the rolls cause and emergency stop again, qualified service technicians
should inspect the machine to solve the problem. Do not attempt to override this safety feature.