User’s Guide U3025-90001
11
U3025AE10
Front and Rear Panel Features
Standby Switch
Note that this switch is Standby only, not a line switch. The main power cord can be used
as the system disconnecting device. It disconnects the mains circuits from the mains
supply.
Active LED
When the Test Set is connected and addressed by a PNA-X, the LED is On (illuminated).
The LED is Off (not illuminated) when the Test Set is in Standby, or not addressed by the
PNA-X.
Figure 4
U3042AE04 Rear Panel
Test Port LEDs
An illuminated LED indicates an active port in Source or Receiver mode. On the front
panel “S” indicates Source test ports and “R” indicates Receiver test ports.
Bias Tee Inputs - Option 001 (only)
BNC female Connectors.
Pass Through Interface
Connection to another Test Set.
Test Set Interface
The Test Set Interface connector is used to send address and data to the Test Set from the
PNA.
Line Module Test Set Interface Pass Through Interface Ground
Bias Tee Input (Option 002)
This Manual:http://www.manuallib.com/agilent/u3025ae10-test-set-user-guide.html
