Agilent Technologies TPS-compact X3580-64000, User Manual

Page: 302 / 312

17 Technical Information
Service Options
302/312 TPS-compact User Manual / 87-901-010-01 (F )
5
If compressed air is available, blow any remaining seal debris off
the scroll parts. If seal debris is attached to the sides, use a razor
or Exacto knife to scrape the debris off.
To Install the new Seals and O-Rings
1
Unpack the Tip-Seals.
Two tip seals are provided in the kit; one fits the orbiting scroll
and the other fits the out-board housing scroll.
2
Install the correct tip seal into the groove of the orbiting scroll by:
a
Facing the white plastic surface upwards and inserting the
foam backing into the groove. Start from the center and work
outward.
b
Cutting the tip seal off about 1/8" (3 mm) from the outer end
of the groove.
3
Install the correct tip seal into the groove of the outboard housing
scroll as in step 3.
4
Place the new main O-ring into the groove in the frame.
5
Ensure that the groove is clean.
6
Ensure the sealing face of the outboard hous-ing is clean.
Carefully replace the outboard housing by lining up the locating
pins. Ensure the tip seal has not fallen out of its groove.
7
Reinstall (4) M5 bolts (B) and torque the (4) M5 bolts to 5.6 Nm
(50 in-lb).
8
Unlock the upper part of TPS-compact by sliding the small lever
you can find on the bottom side of TPS-compact.
9
Reconnect the TPS-compact to the electrical power mains.
10
Disable the “TIP-SEAL SERV” warning message by serial
interface. To disable the Tip-seal Service message you have to
reset the Tip-seal hour-meter (Win 358). Write a “0” on the
window 358. The message will be showed again after 5000 h of
operation. To check the Tip-seal life you have just to read the
Win 358.