Installing the flow manifold
9
Caution
If your current top rear panel is not similar to the one shown in Figure 4,
discard it and use the new one supplied with your accessory kit.
5.
Using a pair of needle-nosed pliers, remove the appropriate top rear
panel detector cutout for the NPD. Also remove any cutouts needed to
access other manifolds or accessories installed in the GC. See Figure 4.
Figure 4.
Top rear panel cutouts
6.
Place the top rear panel on its left-most mounting screw. Work from left
to right and use the screw as a hinge, slide each manifold ID tag through
its cutout in the panel. When all the tags are through the panel, finish
installing the panel on the GC.
7.
Install the RFI shield, the pneumatics cover, and the detector top cover.
Insert tip of
pliers here
Front detector
Back detector
Front inlet
Back inlet
Auxiliary
Left-most screw slot
Summary of Contents for NPD
Page 27: ......
