Agilent Technologies HP 82335, Install Manual, Page: 26 / 54

Note
Hardware
Installation
Setting the Configuration Switches
Use Table 2-1 of switch positions to select the desired memory address ranges
for each HP
82335
interface.
Table 2-1. HP 82335 Switch Sellings for Memory Address Ranges
Switches Memory Segment Range
1 2 3 4
0
1
1 1 DCOO-DFFF
0 1 1 0 D800·DBFF
0 1 0
1
D400-D7FF
0
1
0 0
DOOO-D3FF
0 0 1 1 CCOO-CFFF
The chosen memory address ranges must nOl conflict with other imerfaces
installed in your computer, including other manufacturer's products. Refer
to the documentation for the other interfaces and the previous table to select
unique memory addresses for all interfaces in your computer.
Additionally, these memory ranges may be used by memory management
software including 16-bit Windows. You must specifically exclude the use
of the segment required by the HP
82335
from those segments available to
the memory management software.
Before installing the
HP 82335
and booting the computer, check for a
memory manager device line (for example,
DEVlCE=EMM3 8 6
.
EXE)
i n the
CONFlG.
SYS file in the root directory. Add a parameter to exclude the
memory segment to the memory manager line for the segment used by the
HP 82335
interface. For example,
DEVICE=EMM3 86. EXE X=DCOO­
DFFF
is used for the card's default memory range. Remember, you must
reboot the computer for any changes to take effect.
Before you start Windows, you must also edit the SYSTEM.
1Nl
file in your
Windows directory and add a memory exclude line to the (386enh]
section. For example,
EMMEXCLUDE=OOCOO-ODFFF
is used for the card's
default memory range.
Chapter 2
17