9
4.
Use a 7/64-inch hey key to remove the two screws that hold the end plates
and solenoids together.
5.
Screw the two standoff screws supplied with your actuator kit into the
standoff screws in the existing solenoid valve, then install the new
solenoid valve. Be sure the O-rings are properly seated in the solenoid.
6.
Re-assemble the end plates onto the solenoid assembly.
7.
Re-install the assembly onto the bracket.
8.
Cut the tie-wrap around the tubing leading from the actuator and route the
tubing as shown in the next figure. The tubing from the side of the actuator
connects to the outside fitting on the solenoid (the fitting farthest from the
main board). Trim the tubing as needed to keep installation neat. See
page 10.
Standoff screws
