3
Installing the actuator on a heated valve box
WARNING
The valve box is insulated with a fibrous material that can cause irritation to
the skin, eyes, and mucous membranes. Always wear gloves when working
with the insulation. If the insulation is flaky/crumbly, wear protective eyewear
and a respirator.
1.
Install the heated zone kit (if purchased) as described in the instructions
included with that accessory. Leave the GC covers off and the power cord
disconnected.
2.
Hold the upper valve box over a trash can, then remove the pre-cut
insulation from the appropriate hole in the upper valve box. Remove any
excess or loose pieces from around the hole.
3.
Close the valve box.
Valve 1 position
Valve 2 position
Valve 3 position
Valve 4 position
