Installing the flow manifold
8
Installing the flow manifold
1.
If you are installing an inlet in the back position, remove the flow bezel
bracket. Remove the hex nut at the bottom of the bezel support bracket
using a 7-mm nut driver. Set it aside.
2.
Remove the flow-control label plate from the inlet front or back position
on the flow bezel. The plate is glued in place and is removed by pushing
through the openings in the back of the flow bezel and then pulling off
the loosened plate.
Push here
Summary of Contents for G1574A
Page 16: ...Restoring the GC to operating condition 14 ...
Page 17: ......
