Agilent Technologies Eyesys Mini-B/A, Instruction Manual

Page: 34 / 42

Eyesys Mini-B/A Gauge Controller
20
* Current system status, and not necessarily the last remote command sent.
Error Messages
Eyesys indicates error conditions or responds to incorrect commands with the messages
listed in Table A-2.
Read Sensitivity #aa54I1{cr} >xx.x {cr}
Set Setpoint Pressure Level #aa6hI1x.xxxE–xx{cr}
where range is from
1.000E-8 to 1.000E-01 Pa
or
1.000E-10 to 1.000E-03
Torr or mbar
and
h is Setpoint No. and = 1 or 2
>{cr}
Read Setpoint Pressure Level #aa8h{cr}
where
h is Setpoint No. and = 1 or 2
>x.xxxE-xx{cr}
Reading Valid Status #aa CØ{cr} >01 if DATA VALID
>00 if DATA INVALID
(indicates clearing of factory
calibration)
Table A-2 Eyesys Error Messages
?FF
❑
Command does not follow one of the above formats,
the command or data is invalid, or the command length is
incorrect.
There will be no response to a wrong address, parity
error or lack of termination character.
?Local
❑
A “Set” (i.e., “Set Setpoint Pressure Level” or
“Set Emission Off”) command was received by Eyesys
when in Local Control
0.000E-00
(in response to Read Pressure Command)
❑
Emission not on.
3.000 E-10 (approx.)
❑
Pressure below range of Mini-BA
E05, E06, E09
(in response to Read Pressure command)
❑
See Error Conditions section of manual
Table A-1 Command Set (Continued)
Command Response