Agilent Technologies Eyesys Mini-B/A, Instruction Manual

Page: 5 / 42

Eyesys Mini-B/A Gauge Controller
v
EMC Warnings
EN 55022 Class A Warning
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
FCC
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesirable
operation.
NOTE
The equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generated, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is also likely to cause harmful radio communications
interference in which case the user will be required to correct
the interference at his own expense.
Installation Requirements
To maintain compliance with both the FCC Part 15 rules and the European Union’s EMI
directives, the user must use a shielded cable constructed of a braided shield and metal or
metalized plastic backshells directly connected to the cable shield at the 15 pos D-Sub
connector of the Eyesys Mini-BA. The shield must be connected to ground at the user’s
equipment. Failure to install the equipment in this way may result in the unit no longer
meeting the requirements for radiated emissions and susceptibility.