Agilent Technologies E2050, Installation And Configuration Manual

Page: 27 / 111

Chapter 2 27
Installation
Installing the Hardware
Installing the Hardware
This section shows how to install the LAN/GPIB Gateway hardware by
connecting it to the LAN, GPIB bus, and power module.
Step 1: Record LAN Hardware Address
First, find the hardware address of the LAN interface in the E2050
LAN/GPIB Gateway. Turn the Gateway over and look for the label on the
underside of the Gateway. The hardware address on the label will be similar
to
0800 XXXXXX
. Write down this address, as you may need it later to
configure the Gateway on the network.
Step 2: Configure the Network
n
If you purchased the optional rack mount kit, follow that kit’s
documentation to assemble the rack and to install the Gateway
in the rack’s frame.
n
Make sure the GPIB instrumentation you will connect to the
Gateway is working properly and is connected to the GPIB bus.
Finding the LAN Hardware Address (MAC)
CAUTION: Use only Agilent Technologies
specified AC - DC adaptor.
CAUTION: No operator serviceable parts inside.
Refer servicing to qualified personnel.
POWER: Input: 5V DC, 6 watts
N279
ISM 1-A
Made in U.S.A. of domestic and foreign components
LAN HARDWARE ADDRESS
0800fffffef6