Chapter 2
Installing Memory into an
Agilent E1306A Command Module
Description
You can install one or two 1MByte memory modules into an Agilent E1306A Command Module. The new
memory will be used instead of (not in addition to) the standard 64k of built-in Command Module memory.
Warnings and Cautions
WARNING
SHOCK HAZARD. Only service-trained personnel who are aware of the hazards
involved should install, remove, or configure the system. Before you perform any
procedures in this guide, disconnect AC power and field wiring from the mainframe.
Caution
Do not install or remove modules with power applied to the mainframe. Doing so may
damage the modules and the mainframe.
Caution
STATIC ELECTRICITY. Static electricity is a major cause of component failure. To
prevent damage to the electrical components in the mainframe, plug-in modules, and
memory modules, observe anti-static techniques whenever handling any of this
equipment.
Installation Kit
The following items are included in the memory module installation kit:
•
#10 Torx®* Key - 1 each
•
#10 Torx® screws - 4 each
•
1MByte Nonvolatile Memory Module - 1 each
* Torx is a registered trademark of the Camcar Division of Textron Inc.
Installing Memory into an Agilent E1306A Command Module 2-1
Summary of Contents for E1300B
Page 2: ......