Setting Up the Oscilloscope
To connect a printer
1-22
To connect a printer
If you have a parallel (Centronics) printer, you will need a parallel printer cable,
such as an C2950A (2 m) or C2951A (3 m) cable. Go to step 1.
If you have a serial printer, you will need a 9-pin to 25-pin serial printer cable,
such as an 34398A cable, plus the 34399A adapter kit. Some printers may
require other cable configurations, but the oscilloscope has a 9-pin serial
connector. Go to step 5.
1
Attach the 25-pin small “D” connector to the printer output connector
on the rear of the oscilloscope. Tighten the thumbscrews to secure the
cable.
Figure 1-15
Attaching the Small “D” Connector
2
Attach the larger 36-pin “D” connector to the printer. Latch the wire
bails into the tabs on each side of the connector.
Figure 1-16
Attaching the Larger “D” Connector
Port on Printer
Summary of Contents for 54810A
Page 5: ...1 Setting Up the Oscilloscope ...
Page 37: ...2 Working in Comfort ...
Page 41: ...3 Using the Oscilloscope ...
