User manual version 1
AV dsp amp
In all other setups the jumper is not placed!
When you want to set the master as right channel with analogue
input you will have to change the input cinches, left in the
right cinch and right in the left. This is because only the right
channel is linked trough, so if you want the left channel to be
linked trough you just switch left and right. For digital
sources the left and right channel are linked.
2 Channel:
Connect the module to your pc by a USB cable and select what kind
of 2 channel you want to setup. When you want to set the master as
right channel with analogue input you will have to change the
input cinches, left in the right cinch and right in the left.
This is because only the right channel is linked trough, so if
you want the left channel to be linked trough you just switch
left and right. For digital sources the left and right channel
are linked. An example is given in the last chapter of this
document.
On all setups there is also the ability to use the Line out sub. This can source
an active subwoofer module.
When 2 modules are used these two can be linked by a trigger cable. This cable
holds device data and also carries a audio channel on analogue source. If the
digital board is installed then the SPDIF link cable can be used to communicate
between the 2 modules. This cable is placed from master SPDIF out to slave SPDIF
in cinch. The trigger cable is no longer needed in this setup. On USB audio
input on the master the SPDIF output is also used for linking master to slave.
- 9 -
PC amp V1.0
Led
Volume
Down
Volume Up
Ir Reciever
On/Off
Stereo
audio in
Control
Panel
t
right ch
LF HF
LF HF
Figure 4
Summary of Contents for AV dsp amp
Page 1: ...User Manual AV dsp amp...
