AGILE 5250 ALLY Users Guide and Reference
Page B-20
Command:
Set Initial Conditions (SIC)
Format:
2B D2
nn
45
ic
Printers:
3812, 5219
Action:
This command resets all system-changeable settings to
one of two sets of default values.
The
ic
parameter specifies the initial condition of the
printers settings. An
ic
value of FFh specifies the Data
Processing condition set (DP); an
ic
value of 01h
specifies the Word Processing condition set (WP).
DP
WP
Page Width
13.2 inches
8.5 inches
Page Height
11 inches
11 inches
Left Margin
none
1.5 inches
Right Margin
13.2 inches
7.5 inches
Top Margin
none
1 inch
Bottom Margin
11 inches
none
Typestyle (GFID)
11
87
Lines Per Inch
6
6
Auto New Line
On
Off
Auto New Page
On
Off
An
ic
value of FFh also specifies a job boundary.
On the 3812, an
ic
parameter value of FFh causes the
output tray to be jogged (offset).
IBMEMUL:
Same as the 3812.
When the 5250 ALLY receives this command with the
ic
parameter set to FFh, it sends PFS 43 JOGOUT to the
target printer. This PFS is usually used to jog (offset) the
output paper tray.
Besides the target printer settings that are reset by this
command, the 5250 ALLY also sends PFS 4B
JOBSTRT to the target printer if the
ic
parameter is set to
FFh (DP). By default this PFS is unused. It can be used
to reset duplex or 2-up print modes at the target