9
Install The Spreader Pan Assembly
4. ASSEMBLY
Position the spreader assembly so that it’s resting on the top of the inlet funnel. (The assembly will
be upside-down compared to the view on the previous page).
Note that the flow response funnel assembly is spring loaded:
1. Squeeze the two outside rings together, compressing the springs, and position the assembly
so that the shaft coupling can be accessed.
2. Maintain this “working position” using two C-clamps on both sides.
3. The gear reducer is supplied with the shaft coupling in place. The shaft coupling has a thru-
hole on one end with 5/16” hardware in the hole. Leave the BOTTOM 5/16” hardware in place
and verify secure.
4. Remove the TOP 5/16” hardware and save for re-insertion later.
5. Position the shaft weldment of the spreader pan assembly thru the flow response funnel and
into the shaft coupling.
6. Position / rotate the spreader assembly until the TOP 5/16” bolt can be reinserted back thru the
coupling & shaft weldment.
7. Secure the assemblies together with the 5/16” locknut.
FLOW RESPONSE
FUNNEL
(#1 & 2)
TO ALLOW BETTER WORK
SPACE, RE-POSITION FLOW
RESPONSE FUNNEL & C-CLAMP
IN TWO OPPOSITE PLACES
(#3)
LEAVE IN BOTTOM
5/16” HARDWARE ON
THE SHAFT COUPLING
(#5)
SHAFT WELDMENT OF SPREADER PAN
ASSEMBLY GOES THRU FLOW RESPONSE
FUNNEL AND INTO THE SHAFT COUPLING
(#4, 6, & 7)
TOP 5/16”
HARDWARE IN SHAFT
COUPLING