Chapter 2 — Installing the scanner
29
n
If you install the scanner between two other devices:
Caution:
In this configuration you are not allowed to put the terminator on the scanner.
1.
Disconnect the two devices between which you want to install the scanner.
2.
Set the scanner to an unused SCSI ID number between 1 and 6.
3.
Connect the 50-pin end of the SCSI cable to the connector at the rear of the adjacent device.
4.
Connect the 25-pin end of the cable to the scanner's 25-pin connector.
5.
Connect the scanner to the next device in the SCSI chain.
6.
Make sure that the last device in the chain is terminated.
Summary of Contents for StudioStar
Page 27: ...Chapter 2 Installing the scanner 27 ...
Page 35: ...Appendix A Using the transparency option 35 6 Lower the transparency option ...
Page 40: ...Appendix B Using the document feeder option 40 ...
Page 42: ...Appendix B Using the document feeder option 42 10 Raise the transportation module ...
