AGFA SelectSet Avantra 20, Operating Manual, Page: 51 / 174

Using the Imagesetter Control Panel 2–15
Starting Up and Shutting Down
the Imagesetter
Starting Up the Imagesetter
Follow these steps to start up the SelectSet Avantra imagesetter:
1. Turn on the imagesetter. Press the top of the power switch located
to the left of the control panel. A progress bar appears at the
bottom of the control panel screen as the imagesetter starts up.
Figure 2.6 Screens that appear as you start up the SelectSet Avantra imagesetter.
2. When the imagesetter is ready to accept jobs, the Run screen
appears on the control panel unless the RIP is not connected.
If the RIP is not connected, the control panel displays error
message 15 (No RIP).
Figure 2.7 Error 15 appears if the RIP is not connected.
15
SYSTEM START-UP
DL: xx
OCP: xxxx
DIAG: xxxx
CORR: xxxx-xx
DSP: xxxx
DEC: xxxx
BRDG: xxx
➁
➀
F
#1
PL
#2
A
B