AGCO Massey Ferguson 533, Workshop Service Manual

Page: 15 / 31

Tractor Specification
MF 533/543/563 - Issue 1
1B-5
BRAKES:
POWER TAKE-OFF:
Maximum permissible load capacity:
533...................................................................................... 3628 kg.
543/563............................................................................... 4536 kg.
Rear track settings (all at 102 mm increments):
Pressed steel wheels:
533................................................................................. 1220 mm to 1930 mm.
543/563.......................................................................... 1425 mm to 2130 mm - standard axle.
543/563.......................................................................... 1220 mm to 1930 mm - narrow axle.
PAVT wheels:
563.................................................................................. 1425 mm to 2130 mm.
Rear wheel nut and bolt torques:
Wheel nuts - disc to hub - 1/2 in studs................................ 270 Nm.
Wheel nuts - disc to hub - 11/16 in studs............................ 325 Nm.
Rim clamp nuts (PAVT)....................................................... 260 Nm.
Cast center to hub................................................................. 325 Nm.
Tractor Models applicable:
Brakes
Foot brakes - 533 direct drive............................................. 355 x 50 mm drum brakes, mechanically operated,
together or independently to assist steering.
Foot brakes - 543/563.......................................................... Oil immersed mechanical operation, disc brakes,
epicyclic drive operated together or independently to
assist steering.
Parking brake- all tractors.................................................... Operates on both rear wheels at the same time
independent of the foot brakes.
Tractor Models applicable:
Power Take-off (PTO):
Live PTO - 533,543,563...................................................... Engine and ground-speeds are engaged by a lever on the
left of the center housing.
Independent PTO (when fitted)........................................... Hydraulic clutch, operated by a single lever.
PTO Speeds......................................................................... 540 rev/min.
Shaft Diameter.................................................................... 35 mm.
No. of splines...................................................................... 6.
Engine to PTO shaft ratio - 543/563................................... 3.3125:1.
Engine to PTO shaft ratio 533............................................. 3.1176:1.
Ground speed PTO .............................................................. 533 mm travel equals one PTO shaft revolution.
Ground speed PTO ............................................................. 560 mm travel equals one PTO shaft revolution.
Ground speed PTO .............................................................. 495 mm travel equals one PTO shaft revolution.
4