AGCO Glencoe SF4800, Operator'S Manual

Page: 68 / 75

4-8 LUBRICATION
4-8.1 The flowing table specifies the number
and the period of lubrication points on the
SF4800 Soil Finisher . Proper maintenance
of your machine will, under normal operating
conditions, help to keep it operating at or
near its peak performance for an extended
period of time. Proper maintenance is also a
condition of keeping your warranty in good
status. (See Figure 4 -11)
4-9 STORAGE
4-9.1 The service life of the Soil Finisher will
be extended by proper off-season storage
practices. Prior to storing the unit, complete
the following procedures:
a. Completely clean the unit.
b. Inspect the machine for worn or defective
parts. Replace as needed.
c. Repaint all areas where the original paint
film is worn off.
d. Grease all exposed metal surfaces of
shanks, points and discs.
e. Lubricate each point of the machine as
stated in Section 4-8.
4-9.2 Store the unit in a shed or under a tar-
paulin to protect it from the weather. The
ground tools and tires should rest on boards,
or some other object, to keep them out of
the soil.
4-11
GENERAL ASSEMBLY
ITEM DESCRIPTION NO. OF
LUBE
POINTS
INTERVAL (Hours
unless stated)
1
Radius rod
2 50
2
Pivot bracket (mast)
3 10
3
Pivot block (rockshaft)
1 10
4
Rockshaft bearing blocks (frame)
2 each 10
5
Rockshaft bearing blocks (wings)
2 each 10
6 Walking beams 1 each 50
7
Disc gang bearings
1 each 10
8 Disc rockshaft bearing blocks 2 each 10
9
Basket bearings ( not shown)
1 each 10
10 Ratchet jacks (disc adjust) 2 each 50
11
Wheel bearings
Each Yearly