AGCO Glencoe CC4450, Operator'S Manual

Page: 15 / 37

OPERATION
FOLDING AND UNFOLDING WINGS
To fold or unfold the wings on folding models, turn
the selector valve to “WING FOLD” position.
WARNING! TO AVOID SERIOUS INJURY OR
DEATH, STOP TRACTOR ENGINE,
DISENGAGE PTO, SHIFT TO PARK
POSITION OR SHIFT TO NEUTRAL
AND SET BRAKES BEFORE
LEAVING TRACTOR.
Start the tractor and operate the valve controlling the
disc cutter frame to raise or lower the wings.
After wings are folded or unfolded, return the
selector valve to the original position, allowing
independent control of the disc cutter frame.
Allow the wings to fully rest on wing frame stands
when folded.
DEPTH CONTROL
All Models - Main and Cutter Frames
When desired depth is attained, add stop collars to
the main frame lift cylinder rod so the implement will
return to the same depth each time it is lowered.
Install the thickest collar nearest the cylinder. Store
remaining collars on storage racks.
Use the same procedure for regulating cutter frame
depth.
Note: Stop collars are not used on main frame or
cutter frame wing cylinders .
DEPTH CONTROL SYSTEM
An electronic depth control system is available as an
option (see OPTIONS Section). An operator’s
manual is included with the depth control bundle.
See your dealer for additional information.
LIFT CYLINDER OPERATION
Folding Models
The master lift cylinder and wing slave cylinders
should extend and retract equally to maintain the
same depth. To ensure equal stroke length,
occasionally hold the tractor depth control lever in
raise position for a few seconds after raising the
implement.
Note: The procedure can be conveniently performed
when the implement is raised while making a turn.
11
Fig. 16 - Selector Valve
1. Valve
Fig. 17 - Cutter Frame Cylinder
1. Cylinder 2. Stop Collars
Fig. 18 - Main Frame Lift Cylinder
1. Cylinder 2. Stop Collars
2
C445-13A-1
1
2
1
C445-3B-1
1
C445-14A-1