If the 'cook'
symbol is not
displayed the
programme has either:
Ended and the oven is
non-operational or,
The oven is being
contolled by an
automatic programme
that has not started.
You can use the clock (Fig. 8) to turn the oven on and
off. Only the left hand lower fan oven is controlled by the
oven timer. The clock must be set to the time of day
before the oven will work .
The table below describes the symbols shown on the
digital display.
Fig. 8
DESN 517079
Symbol
Function
Notes
[AUTO]
[dot]
Minute Minder is on
Oven can be
operated
Oven is being
controlled in
semi-automatic or
automatic mode.
Flashes during
setting the time of
day.
• Press and hold both the and buttons down
(Fig. 10). Now press the [+] button (
or {-] button
) until
the correct time shows.
• Press and hold the button. Now press the [+] or [-]
buttons to increase or decrease the time (Fig. 9).
Holding the [+] or [-] buttons for more than 2 seconds
will advance/decrease the set time quickly. Release
the buttons to set the time of day.
Fig. 9
DESN 517066
Do not forget that it is a 24-hour clock .
If you need to reset the clock/cooker, turn off the power
and wait several minutes, then start again.
Fig. 10
DESN 517067
SETTING UP THE COOKER FOR USE
Setting the Time of Day
When the cooker is first connected to the mains, or if
there has been a prolonged power interruption, the clock
display flashes [ 0.00 ] and [AUTO].
During the time setting process the centre dot will flash.
When the process is complete the dot will stop flashing
and the
symbol will be displayed.
The time of day can be set in two ways:
15
Summary of Contents for Six Four Series
Page 12: ...Users Guide 12 ...
Page 33: ...33 SCHEMATIC WIRING DIAGRAM ...
Page 34: ...34 ...
Page 35: ...35 ...
