GB & IE
AGA Ellesmere Standard Gas Stove
39
4. Servicing
Turn the appliance OFF and isolate the gas supply. Ensure the appliance is fully cold before attempting
to start servicing the appliance. No liability can be accepted by AGA Stoves for injury caused by burning
or scolding by a hot appliance.
A suggested only procedure for servicing is listed below.
A. Lay out dust sheet on flooring, mask off any special fireplace materials.
B. Open Outer Firebox Door and remove inner glass panel
C. Carefully remove the Ceramic components (including Embers)
D. Use a Vacuum cleaner to clean the top of the burners and grate
E. Remove Grate
F. Use the vacuum cleaner and a soft brush to clean the pilot assembly and Injectors. It may be
easier to access the Injector by removing the Throttle. Never modify or bend the Thermocouple.
G. Clean the Window Panel.
H. Turn on the gas supply and check for leaks, check the burners and Pilot for good condition and
operation
I. Replace the Grate front and back
J. Replace the Fire bed arrangements as per the approved layout
K. Check inner glass seal, replace if damaged, replace glass frame, do not over tighten the screws
Close door.
– please ensure no finger prints are on the glass
L. Check the flue system and terminal, making sure that the terminal vent is fully clear
M. Light the appliance and test setting pressures
N. Check the safe operation of the appliance.
4.1 Cleaning the Ceramics
Remove the ceramics as detailed in A - E above.
Gently clean the ceramics in the open air, using a soft brush and a vacuum cleaner. Where necessary
replace damaged components only with genuine AGA Stoves specified parts. Seal any scrap ceramics
in plastic bags and dispose of at a proper refuse site. When using a vacuum cleaner, it is recommended
that one with a HEPA filtering system is used. The ceramic Log set & Embers contains RCF
’s
Re-fit the Fire bed arrangement, re-seal the appliance and check the safe operation of the appliance.
4.2 Servicing the Burner
A fault finding chart is included in the appendix for the control system fitted to this appliance.
Access the Burner as detailed in A - F above.
The pilot is now clearly visible, the pilot, including the Thermocouple, can be replaced/serviced by
removing raising the pilot assembly from its mounting. This is done by removing the two screws on the
surface of the pilot. The fittings on the under-side of the pilot can be un-done using a 10mm spanner
where appropriate.
The Main Burner Injector can be accessed from the underside of the appliance. If the burner needs to be
removed, this may be done by removing the 4 x M6 fixings inside the firebox (10mm Spanner), the
burner will lift out through the Firebox as one complete unit
The receiver/controller unit is fitted into a heatproof box at the rear of the stove, when removing it be
careful not to damage the wiring loom or any of the multi plugs. The battery lead can be removed
THE STOVE IS FITTED WITH AN EXTERNAL BATTERY PACK DO NOT FIT ANY BATTERIES INTO
THE RECEIVER UNIT, AS THIS WILL CAUSE PERMANENT DAMAGE WHICH IS NOT COVERED
BY YOUR WARRANTY
When replacing any parts use only original AGA Stoves specified parts.
