760-738-4084
Hours
Monday - Friday 8:00 AM - 5:00 PM PST
Address
545 Corporate Dr, Escondido, CA 92029
Phone
760-738-4084
AUX-USB Plug Saver Instructions
Before installing we recommend watching AGA AUX-USB Plug Saver video on our
Step 1:
Start by fishing the AUX connecter out of the
hole it has fallen into. Align with a pick on the
inside and use a screw driver from down
below.
Step 2:
Once the connecter is out, make sure the wires
don’t fall back into the hole. Carefully push on
the plastic tabs and disconnect the two
connectors to the AUX-USB power.
Step 3:
To install the AUX-USB Plug Saver, slide it over
the housing of the connector, until it clicks into
place.
NOTE: Push metal frame over the metal
tabs at the same time to avoid bending the
USB-AUX Plug Saver.
Step 4:
Connect the USB power then connect the AUX
connector back to the back of the switch. Push
the wires in and push the switch back down.
NOTE: If area where metal tabs make
contact is damaged, it may be necessary to
clean up center console with exacto knife or
similar. Carefully bending the metal tabs
outward on USB-AUX Connector to increase
tension may also be needed.
