4
5
Powering ON
Press and hold the Power Button for 3 seconds and the headphones will turn ON with a "Power
ON" announcement.
When the power is ON, the Bluetooth/ANC Status Indicator flashes in blue at a regular interval.
When the power is ON with the ANC function is activated, the Bluetooth/ANC Status Indicator
flashes alternately in blue and green at a regular interval.
Powering OFF
Press and hold the Power Button for 5 seconds and the headphones will turn OFF with a "Power
OFF" announcement. When the power is turned OFF, the Bluetooth/ANC Status Indicator lights up
red and fades off.
* To fully turn OFF the power of the headphones, please make sure to turn OFF the ANC function
too to prevent extra power consumption. ANC function might remain ON even after turning OFF
the headphone power.
Charging the Headphones
Connect the USB Charging Port to a charging adaptor with the supplied USB Type-C Charging
Cable. The Charging Indicator flashes red while charging and turns green when the headphones
are fully charged.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.