23
13. Lock the outer wheels in raised position to
prevent accidental falling while in road
transport.
14. Remove inner wheel locks from storage I
and place into road lock up position H.
15. Do all locks the same for the right side of
machine.
16. Enter the cab,
17. Drive forward, observing that the wings trail
in behind the center section to the normal
13.5 foot wide transport width.
18. You may adjust the angle of the wings in
transport by turning thread adjust on the
locking pins. The wings trail nearly straight
back
– there should be 6-8” between the 2
wheel assemblies in normal straight ahead
road transport.
19. Measure the distance from the barrel X to
the Wheel Y at both the forward and
rearward steel rim locations. Distance Z
must be ½” greater at the rear than at the
front of the tire on both sides.
20. Continue to next location.
Summary of Contents for LandRoller
