afx light 16-2087, User Manual

Page: 15 / 28

EN 15
www.afx-light.com
POWER LINK
Connect an IEC cable from the POWER OUT connector of the 1st unit to the POWER IN connector of
the second unit, etc.
CONTROL PANEL (FIG. 2)
To access the main menu press the MENU button. Press the UP or DOWN buttons until you reach
function you wish to change. When you reach the function you wish to change, press the ENTER
button. When a function is selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button.
Tip: Press UP & DOWN buttons at the same time for 3 seconds. The display will reverse.
FUNCTION MENU
MENU DESCRIPTION
DMX
DMX address A001-AXXX DMX address setting
Channel Mode
26CH 26 channel mode
38CH 38 channel mode mode
102CH 102 channel mode mode
114CH 114 channel mode mode
Auto run
Internal program 1-8
Auto run State: Master/Alone
Auto run (On/off)
Music control
Internal program 1-8
Sound control
State: Master/Alone
SET
Reset Default Yes/No Reset default
Signal set Wired DMX Wired DMX
Reverse Pan (on/off)
Reverse Tilt (on/off)
Select Pan 630/540/360
Select Tilt 270/180/90 Reverse Pan
Reverse Tilt
Select Pan
Select Tilt
Mic sensitivity 0-99% Mic sensitivity
OFF signal mode (On/Off)
Off at original status and ON at reset sta -
tus
Scan Quick mode (On/Off) Scan Quick mode
Theater mode (On/Off) Fan Silent mode
Totem mode OFF/CEN./R/L
Totem mode: Centre/Right/Left (dé -
fault:Off)
Manual
control
Reset
Total reset
Scan reset
Zoom Reset Reset All
Reset Scan
Reset Zoom
Channel PAN=XXX... Channel control
Advanced
Access code
0888)
Calibration
UID code PAN=XXX...
XX XX XX XX XX XX Calibration
UID code setting