afx light 15-1845, Instruction Manual, Page: 6 / 66

©Copyright Lotronic 2018 Manual DMX512-PRO 6
Unit
Starting address
Unit
Starting address
1 1 17 289
2 19 18 307
3 37 19 325
4 55 20 343
5 73 21 361
6 91 22 379
7 109 23 397
8 127 24 415
9 145 25 433
10 163 26 451
11 181 27 469
12 199 18 199
13 217 29 505
14 235 30 free
15 253 31 free
16 271 32 free
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3
pin connector of the controller.
2. Connect the end of the cable coming from the controller which will have a
(female) 3 pin connector to the input connector of the next fixture consisting of
a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the
following fixture and so on.
Connection to the Mains
Connect the power supply unit to the power input jack and the mains plug to a mains
outlet. Always disconnect the mains connector when you wish to change connections,
move the unit to a different place or if it is not used for a longer period.
Configuration
Adjusting the DMX Starting Addresses of the Light Effect Units
Adjust the DMX starting address of the connected light effect units according to the
following scheme. If identical units are to be controlled synchronously, they can
receive the same starting address; otherwise each unit must receive an individual
address. For further information, please refer to the unit’s documentation.
Table 6.1 Default values for the starting address of the light effect units