3
Figure 4 - CSM Clamp
Photo 1 - C-Half Sections and Center Section Mounting Screws
Photo 2 - Cable Clamp Removal from from Center Section
Photo 3- CSM Clamp Removal
7.0
GROMMETS KIT CONTENTS
7.01
Photo 4
above shows the grommets included in
the cable entry ports and the accessories located
in the sub-component kit bag. The fully round
grommets were placed into the cable ports at the
factory. The grease blister pack, diameter Band-
Mic and ½-grommets are located within the kit
bag. Only remove the cable clamps and
grommets from the ports to be occupied by
cable.
Photo 4 - Grommet Kit Contents
8.0
USING
THE
BAND-MIC
AND
LAYER
REMOVAL
8.01
Wrap the Band-Mic around the cable in the
sealing area to get a diameter reference and to
determine how many grommet layers should be
removed. The Band-Mic should be snug to the
cable. The measurement provided will give the
approximate diameter of the cable and also the
corresponding number of layers to be removed
from the grommet. If the cable diameter falls near
or on the border of an additional layer, use the
fewer number of layers initially and fit the
grommet around the cable for the final fit. Refer
