1
1
2
2
3
3
Turn on your faucet so a steady stream of cold water
flows into the sink.
Locate the cold water valve. It is typically the valve
on the right and can sometimes be identified by a
blue handle.
Use a flashlight or headlamp to locate the 2 water
valves under your sink.
Shut off the cold water supply by turning the valve’s
handle or knob clockwise until tight.
Place a bucket or towel below the valves.
After you’ve shut off the cold water supply, turn off
your faucet.
STEP 2
STEP 3
PREP
SHUT OFF COLD WATER SUPPLY
13
1
2
3
Disconnect the cold water line from the water valve
by twisting with your hand or a wrench.
Refer to the diagram on the front of the bracket to guide you during the following steps.
Connect the stainless-steel hose attached to the
filter’s ‘inlet’ end near filter cartridge 1 (female
fitting) to the water valve (male fitting). Tighten with a
wrench to create a seal.
Connect the stainless-steel hose attached to the
filter’s ‘outlet’ end near filter cartridge 3 (male fitting)
to the water line (female fitting). Tighten with a
wrench to create a seal.
STEP 4
CONNECT FILTER TO WATER LINE
14
