Page 8
Refer to Figure E for Steps 7-9
Step 7: Locate the MAP sensor jumper harness on the aFe POWER harness. It is the first, shorter set of
connectors coming out of the aFe Power module. It is
labeled “MAP”.
Step 8: Plug the female connector of the aFe POWER harness to the MAP sensor, then take the male
connector of the aFe POWER harness and connect it to the female connector of the engine harness.
Step 9: Check with the picture to make sure the connectors are fully seated and that the locking tab is slid
back into place.
Make sure that the connections are fully engaged and not reversed. Usually, connectors make a
snapping sound when fully engaged.
REMOVAL
Figure E
MAP Sensor Connectors