Afar AR-24010E, Operator'S Manual

Page: 54 / 108

pulsAR radio Operator's Manual
Examples:
> save-configuration destination=alternate
> save
unlock
debug-mode=”ASCII string”
enable-configuration=”ASCII string”
This command unlocks the access to various commands. The enable-configuration password
(set with the change-password command) unlocks the various commands listed in this manual
that alter the radio configuration. The
debug-mode is a factory mode used for troubleshooting
by customer support.
Examples:
> unlock enable-configuration=bh7g8
4.4 Major Configuration Parameters
These commands change several operating parameters of the radio that are part of the radio
configuration. When entering commands with multiple parameters, if a parameter is not
included, that parameter keeps its current value.
distance
maximum=10..500 (km)
units=km
or miles
Sets the limit for the maximum distance of any RF link in this network. You only need to set
this maximum distance at the root or hub node. All other nodes will automatically configure
the maximum distance to that of the parent node.
The units you choose (km or miles) will be used in other displays when reporting the measured
distances.
In general you should leave the maximum distance set to the default value of 80 km (50 miles).
But if you are deploying a network where one or more links exceed this distance you must
change this parameter to a value that is equal to or greater than the maximum link distance.
Increasing the maximum distance results in a slight decrease of the network capacity.
If you enter a value greater than 255 km it will be rounded to 300, 400 or 500 km.
Examples:
> distance 100 km
> distance units=miles
4-6