Afag PEZ-100, Maintenance Instructions Manual

Page: 58 / 60

Seite 58 PEZ-52-65-80-100 BA-vers.1.3 gb
.
15.10.14.doc
4.2.1 Stroke limitation
The stroke limit is used where the mechanical axis of the hub cannot be retracted.
This may arrive at the cross and vertical structures, for example, according to the
pictorial representation below.
As an end-position damping effect on each side two rubber buffer. The stroke limit is
understood as a purely emergency end-stop to damage to the axle and mounted
parts (grab, etc.) should be avoided! The movement is always stopped by the electric
servo drives.
Types Order No.
Stroke limitation to PEZ-52 50403195 (1Piece)
Stroke limitation to PEZ-65 50281376 (1Piece)
Stroke limitation to PEZ-80 50281045 (1Piece)
Stroke limitation to PEZ-100 50281046 (1Piece)
Set-Hubbegrenzung
Components have to be screwed up together in the image
CAUTION
After driving from the axis slides are on the stroke limitation,
the stroke limit check for damage and replaced if damaged.
This ensures that the stroke limitation still operating properly.
Installation of the stroke limitation on the
axis.
Nuts to the desired position in the axis-profile
slots appeal.
Stroke limiting iron defer to the axis profile.
Screws with washers and spring washer use,
stroke limit position and tighten.