Page 14
12/02/2020
R05.1
4.2
Setting the distance between the rail and the support surface
This setting is only necessary when:
-
All spring packages have been exchanged or re-assembled
-
The LF has been dismantled
WARNING
Unplug the power cable, before proceeding with further actions!
1.
Loosen the screws slightly (1)
2.
The distance
X
in front and at the back of the linear feeder has to be the same.
Check the dimension of
X
3.
Tighten the spring package screws again (1)
4.
Check the air gap between the magnetic coil and the anchor bolt and adjust if
necessary
(see chapter 5.4)
Figure 6
4.3
Standard operation
No further settings are required for standard operation mode once the controller is
switched on.
