AEV MMMS3000 - ON AIR CONSOLE
AEV Broadcast Srl
, via della Tecnica 33 – 40050 Argelato (BO) Italy
Web site www.aev.eu e-mail [email protected]
12
General functions
Insert
This function enables to route the microphone signal towards the INSERT output and no longer
to the analog bus; the signal can therefore be used as an input on an external audio processor,
and, once processed, it is subsequently re-introduced on the INSERT input and distributed on the
analog bus. This function is available on connector 1 (pin 4 and 5, if this function is not used,
it will be necessary to place a jumper between the above pins).
Phantom
This function enables the condenser microphones supply and is available on all microphone inputs.
Its relevant enabling is carried out on connector 1 (simply by placing a jumper between pins 6 and
7).
Start
The slider is switched with a micro-switch enabling the module START .
Stop
The slider is switched with a micro-switch enabling the module STOP.
Slider
Beside the channel audio level control standard function, the Slider enables the Start mode when
turned up and the Stop mode when turned down. As regards the remote controls, please, refer
to the information above.
Tally
When a channel has this function enabled at startup, a stable contact is set on, it is on Start and
routed to the PGM bus; the function is enabled by pressing PGM at startup.
OUT/AUX Configuration
The following inputs and outputs are available on the mixer: - two external analog inputs EXT 1
and 2 - a PGM analog output – a UTL analog output - an AUX analog output.
Direct controls
Control Room Area
The Control Room audio output level may be adjusted via the C. Room potentiometer located
on the panel.
E
XT
1
When the EXT1 button is pressed, the following functions are set on: the EXT1 input signal is
sent to the Control Room output, and the function previously set on the Control Room bar is
disabled. The adjustment of Ext1 auxiliary input level can be set via the related potentiometer,
within a range of -12 ÷ +12 dB.
E
XT
2
When the EXT2 button is pressed, the following functions are set on: the EXT2 input signal is
sent to the Control Room output, and the function previously set on the Control Room bar is
disabled. The adjustment of Ext2 auxiliary input level can be set via the related potentiometer,
within a range of -12 ÷ +12 dB.
PGM
When the PGM button is pressed, the following functions are set on: the PGM input signal is
sent to the Control Room output, and the function previously set on the Control Room bar is
disabled.
UTL
When the UTL button is pressed, the following functions are set on: the UTL input signal is
sent to the Control Room output, and the function previously set on the Control Room bar is
disabled.
AUX
When the AUX button is pressed, the following functions are set on: the AUX input signal is
sent to the Control Room output, and the function previously set on the Control Room bar is
disabled.
When any module CUE button is pressed, the selection lashes and the output signal is replaced
by the signal of the module on which Cue was pressed.
