AEV ITB302 - dual digital telephone hybrid
AEV Broadcast Srl via della Tecnica 33, 40050 Argelato (BO) ITALY
www.aev.eu
- mail :
3
The equipment is to be used by people capable of operating it in a trouble-free manner and
it
is assumed that they are aware of the following safety rules.
• Keep this manual with the utmost care and close at hand so that it can be consulted
whenever needed
• After unpacking the equipment, check it for condition.
• Avoid banging the equipment.
• The packing material (plastic bags, polystyrene, nails, etc.) must never be left within the
reach of the children, as
these items are potential sources of danger
.
• Do not use the equipment in places where the temperature is not within the recommended
range, as specified by the manufacturer.
• Before connecting the equipment, make sure the nameplate specifications correspond to the
mains electricity supply (the nameplate is located on the equipment enclosure).
• Do not remove the sticker from the equipment as it contains important specifications and the
relevant serial number.
• To join the equipment to the mains supply, use the power cord purchased with the
equipment.
• The equipment must be used only for the purpose it was designed for.
• Abuse or misuse of the equipment is
extremely dangerous
for people, pets and property.
The manufacturer declines all responsibility for damage and injury resulting from
improper
use
and
mishandling
.
• Certain basic safety rules must be observed when using electrical equipment, in particular:
- Never touch the equipment with wet and/or damp hands or other parts of the body.
- Keep the equipment away from drops of water or sprinkling systems.
- Never use the equipment near high heat sources or explosive material.
- Do not introduce any extraneous matter into the equipment.
- Do not allow children or untrained people to use the equipment.
• Before cleaning or servicing the equipment outside, disconnect it from the supply and wait at
least 2 seconds before working on it, as recommended by current safety regulations.
• In the event of faults and/or improper operation, turn off the equipment, shut off the
electrical power and call your dealer.
covers/guards or circuit boards are to be removed.
• Blown fuses inside the power supply indicate that there may be a fault in the power supply
itself. The fuses must be replaced by qualified and authorised persons. It is advisable to call
your nearest dealer.
• Call your dealer for any repairs and be certain original spare parts are used.
Failure to
observe this rule may adversely affect the safety level of your equipment
.
• The equipment is to be connected to the mains supply and provided with adequate and
efficient earth conductors.
• The electrical wiring must be done in compliance with current electrical codes CEI 64-8
“Electrical specification for domestic buildings”.
• When installing, leave a clearance of at least 1 cm around the equipment to allow air to pass
freely.
NOTE. This piece of equipment has been manufactured to the highest standards of
workmanship. It must be used properly and serviced as recommended to ensure
long-term dependable operation.
The installation must be done in order to be able to guarantee an easy access to the cable of
feeding.
The device of dissection of the equipment is the cable of feeding, so it must be unconnected
from the equipment every time it is ecessary to do any type of maintenance.
