BESA-12P User’s manual
-
17 -
www.aetool.com
AETOOL LTD.
Page 23
Testing on stand-alone batteries:
Clean the battery posts with a wire brush prior testing. For side post batteries,
install stud adaptors. Do not use steel bolts for better results.
1. Attach the Analyser clips onto the battery terminal posts [Red to (+) and
Black to (-)] the unit will power up and lights up the LCD display screen as
shown (Fig.19).
2. It will run through a self-test and when completed it displays the Main Menu
as shown: (Fig. 20)
Here, it will let you select your choice from the Menu:
New: Clear Memory
Selecting this item will allow the tester to clear the last tested results stored
in its memory and begin a new test.
Continue Testing
Selecting this item will allow you to continue the last test on the same car
from where you had stopped.
For example:
If you had done Battery Test and later you wish to do Alternator Test or
Grounding Test on the same car, just select this item and it will update the
results after each test in its memory so that it can be review later or to be
printed out.
Figure 19
Figure 20
BESA-12
BATTERY ELECTRICAL
SYSTEM ANALYSER
Select Menu
New: Clear Memory
Continue Testing
View last Test
Setup Menu
[Enter] to proceed.
