Aerus LAUNDRY PRO, Owner'S Manual

Page: 4 / 32

4
ELECTRICAL REQUIREMENTS
100 - 240 Volt 50/60 Hz 5 AMP (minimum) Fuse or Circuit Breaker.
Laundry Pro is equipped with an AC to DC power supply.
NEVER USE AN EXTENSION CORD.
WATER REQUIREMENTS
A dynamic water pressure of 20 to 75 psi is required to correctly
operate your Laundry Pro. See Cautions below.
CABINET FEATURES
WATER
OUTLET
WATER
INLET
INSTALLATION REQUIREMENTS
LOCATION CONSIDERATIONS
It is recommended the Laundry Pro never be installed in areas
where water may freeze since the unit will always maintain some
water in the unit, the water valve, and hose areas. This can cause
damage to internal components. It is also recommended to avoid
installation in areas of high humidity, as it can effect the operation
of the unit.
17.25” (438 mm)
9.6” (244 mm)
4.05” (103 mm)
Incoming water pressure must be less than 75 psi. If your household water
pressure is greater than 75 psi, you must install an in-line pressure reducer before
installing Laundry Pro. Failure to follow these instructions may result in water
leakage, property damage, personal injury, and may void your warranty.
Water
pressure of 20 to 75 psi is required to correctly operate your Laundry Pro. Low water
pressure may prevent your unit from operating properly and/or cause a failure in your
washing machine’s water valve.
The washer’s water valve may also not shut off completely. Check the documentation
supplied with your washing machine for exact specifications. Your washing machine
and cold water faucet must be within 4 feet of the right side of the unit to use the inlet
hose provided with your Laundry Pro.
TO AVOID THE POSSIBILITY OF WATER DAMAGE, SHOULD A HOSE LEAK, ALWAYS
HAVE FAUCETS ACCESSIBLE AND TURN OFF FAUCETS WHEN WASHER IS NOT IN
USE.
Water quality may affect the performance of your Laundry Pro unit.If you have water
quality concerns such as high iron content or high chlorine content, consult a water
filtration expert. This system is designed for use on potable water systems only.
CAUTION: