Aerus LAUNDRY PRO, Owner'S Manual

Page: 11 / 32

11
When connecting hoses to your
Laundry Pro hand start the hose
connector(s) Using adjustable pliers
finish tightening hose connector(s).
CAUTION:
Some washing machine models require water to flow through both the HOT
and COLD valves for proper operation. In some cases, if only the COLD water
side is connected, the water valve will not operate or the washing machine
will not fill to the proper level. To solve this problem, the installation of a “Y”
adaptor (available at most hardware stores) may be used. The use of the “Y”
adaptor allows water to flow equally through both the HOT and COLD water
valves. Optional stainless steel hose (49701) must be installed on the hot water
connection. To Install, turn water off at the valves and disconnect the existing
HOT water hose (at the valve and washing machine) Connect the “Y” adaptor
to the Outlet on your Laundry Pro, then connect both the optional stainless
steel hose (49701) and Cold hose from your washer to the “Y” adaptor (see
diagram below). Operate your washer on the WARM/WARM setting (your
Laundry Pro will still be
using just cold water).
Turn off both water valves (hot and cold)
before disconnecting hoses. Failure to
follow these instructions may result in
water leakage and/or possible injury
from hot water.
CAUTION:
NOTE:
Your hot source water valve
will not have a hose connected to it.
Make sure it is fully turned off. It is
recommended you secure a cap
(available at most home improvement
stores) to prevent leakage.
FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT
Connect to household plumbing
COLD water valve
“Y” adaptor
Make sure the “Y” adaptor
valve is in the on position.
Connect to HOT water inlet
on washing machine
Connect to COLD water inlet
on washing machine
Disconnect the existing hose
from the HOT valve and washing
machine and remove. Replace
with optional stainless
steel hose.
Part No. 49701
(not included).
Disconnect this stainless
steel hose from the
OUTLET on your
Laundry Pro,
then connect
it to the “Y”
adaptor.
Connect the “Y” adaptor to the
OUTLET on your Laundry Pro. Be
sure to hold the fitting with pliers
while tightening the adaptor.
Stainless steel hose supplied
with Laundry Pro.