AERPRO AERA10D
®
Radio Replacement Kit
for 2011-2018 Jeep Wrangler JK
AMHJP1K
Page 12
Step 8
Install the front frame by hooking
at the top first, then snapping in
the sides and bottom. Remove
the tape by pulling downward.
Part Three: Attaching the Display Panel (cont.)
Section 4: Radio Unit Installation (cont.)
Step 7
Once the display panel is
locked into place, use a Phillips
screwdriver to tighten the two mount
screws on the left and right sides of
the mounting panel.
Reset / Restoring Interface Factory Settings
You can restore the RadioPRO interface module to factory default settings by pressing and holding the programming button
on the side of the module until the status LED starts blinking red. Once the LED starts blinking red, release the button. You
must release the button while the LED is blinking red in order to perform the reset. This reset will restore all settings to factory
defaults.
Email:
Phone:
03 8587 8889
FAX:
03 8587 8866
Technical Support
Reinstall the remaining screws, panels and switch pod to complete the installation
