49
10.
Slide the nylon outer tube over the throttle
pushrod wire and forward through the hole in
the firewall as shown. Extend the nylon tube
forward of the firewall approximately 1/2.”
Mark the nylon tube over the front of the throt-
tle servo mount as shown.
11.
Remove the nylon tube and cut at the mark as
shown.
12.
Reinstall the nylon tube over the throttle push-
rod. Use needle nose pliers to bend the throttle
pushrod wire 90º up over the trottle servo
output arm hole as shown.
13.
Use wire cutters to cut off the excess pushrod
wire above the throttle servo output arm hole
as shown.
