26
14.
Plug the rudder servo into the rudder channel
of the receiver and power up. Turn on trans-
mitter to center rudder servo. Remember too
center trims and sub trims
15.
Tape the rudder balance tab to the top leading
edge of the vertical fin in the neutral position
as shown. This ensures the rudder is straight
when the cables are attached.
16. Slide brass swage onto rudder cable
17. Attach the RC link with threaded coupler to
the rudder control horn. Next, thread the rud-
der cable through the threaded coupler, and
back through the brass swage tube. With the
rudder servos powered up and centered, pull
light tension on the cable through the coupler
as shown.
