4.2.2.15 Install the tip battens through the access zipper in the bottom surface:
bend the tip batten with angle approx 60 degrees;
install the batten into the sail with bend going towards the wing tip;
install flat end of the batten to the angle of the sail tip;
straighten it a little bit and guide another end of the batten onto the leading edge batten
hook;
pull the bend towards the keel and gently straighten the batten completely.
A
B
C
D
4.2.2.16. Install the washout tips, just swing them to the right place underneath the corresponding top surface
battens through the access zipper in the bottom surface.
4.2.2.17. Remove the protective bag from hang detail.
4.2.2.18. Do a complete preflight inspection of the glider, Section 3.
It is imperative that you carry out this inspection every
time you rig and before you fly.
CAUTION
BEFORE FLIGHT CHECK THAT ALL INSPECTION ZIPS ARE FULLY
CLOSED.
4.3 Preflight Inspection of the wing
Conduct a complete preflight inspection of the wing, checking all assemblies, which have not already been
checked. Every bolt, nut, pin, safety ring, and fastener of any kind should be checked during every pre-flight. A full
pre-flight inspection should precede every flight you make, not just the first flight of the day.
