![background image](http://html.mh-extra.com/html/aeroqual/200-series/200-series_user-manual_2862861002.webp)
1
2
4
1
3
5
Quick Start Guide
1.
Unpack monitor and check supplied components are correct
2.
Insert Battery (see section 3.0)
3. Insert
Sensor
4.
When new, plug in the power adaptor and turn on your monitor
(with sensor head installed) for 24hrs. Note: The battery requires
15hrs from full discharge. The sensor requires a run in period.
Thereafter, the normal warm up takes only 10 minutes. If your unit
is new or unused for a long period, a warm up message may dis-
play for several hours, then will disappear.
5.
Follow the operating instructions to understand how to make the
most of your monitor
Warning:
•
Do not
expose the monitor to gas concentrations above the recommended
maximum range
•
Do not
place the sensor head in a gas stream – the monitor is designed to
measure ambient levels of ozone and uses
‘active sampling’
to achieve this.
1. Sensor
Head
2.
Power and Stand By
3. Display
4. Enter
5.
Battery case. For battery installation, see
section 3.0 of your user guide
ZERO CAL:
Please refer to section 4.5 of your user guide when using this
option, as this can uncalibrate your unit if performed incorrectly
CONC UNIT:
To change the units of measurement, use the power key,
then press to return to the main menu. See section 4.6 of your user
guide for more information
MAX / MIN AV:
To adjust the max / min av, press to alternate between
start and stop. See section 4.7 of your user guide for more information
EXIT
ZERO CAL
CONC UNIT
MAX MIN AV