1 Technical data
Type of tool …………………………………………………………………………………
.
…
ST64X
Outline dimension
………………………………………………………………
.
……
90*275*355mm
Weight
(without fasteners)…………………………………………………
..
……
...
7.27Lbs (3.3kg)
Required pressure
………………………………………………………………
.80-110Psi (5.5-8Bar)
Max. pressure
………………………………………………………………………
.
…
..120Psi(8.3Bar)
Recommended lubricant…………………………………………………
.
……
.white mineral oil 10
＃
1.1 Fastener
Fastener size: Ga14(
Φ
2.2)
Nail length:
18-64mm (3/4
”
-2-1/2
”)
Magazine capacity: 70pcs
1.2 Accessories
Hexagon Key
Lubricant
Operating instruction
1.3 Description/Features
This T-nailer is excellent for wood to concrete steel applications.with lightweight die-cast housing maximizes
productivity by reducing operator fatigue,shoots 14 gauge T-nails from 3/4
”
(18mm) to 2-1/2
”
(64mm) long.
1.4 locations of Parts
(see Figure 1)
A-Magazine
B-Trigger
C-Exhaust Vent
D- Air Quick Coupler
2 Special references
2.1 Instructions
The following standard is applicable to fastener driving tools; EN792-
13:2000+A1:2008”Hand
-held non-electric power
tools-safety requirements
–
Part 13: Fastener driving tools”.
This standard requires that
-
only those fasteners which are specified in the operating instructions (see TECHNICAL DATA)shall be used in
fastener driving tools. The fastener driving tool and the fasteners specified in the operating instructions are to be
considered as one unit safety system;
-
quick action couplings shall be used for connection to the compressed air system and the non-sealable nipple
must be fitted at the tool in such a way that no compressed air remains in the tool after disconnection;
-
oxygen or combustible gases shall not be used as an energy source for compressed air operated fastener driving
tools;
-
fastener driving tools shall only be connected to an air-supply where the maximum allowable pressure of the tool
cannot be exceeded by more than 10%;in the case of higher pressure ,a pressure reducing valve which includes a
downstream safety valve shall be built into the compressed air supply;
-
only spare parts specified by the manufacturer or his authorized representative shall be used in the repair of
fastener driving tools;
-
repairs shall be carried out only by the manufacturers authorized agents or by other experts, having due regard to
D
C
B
A
