Front of
craft
Tech Tip:
Avoid
compressing the
spacers by NOT
over tightening
the screws
Make sure your Locking Tabs both face the front of
your craft while you slide them together like this.
Turn the Locking Tabs down to secure your
Gear Rail Assembly and check these before each flight.
You will notice four free stainless steel bolts on your
Core. These bolt into your Brackets pointed out below
(circles).
Place the locking washer onto the M3x25mm Socket
Head Cap Screw. Hold the Spacer in the space
provided and tighten the screw until firm.
x2
x2
x2
Repeat Step 2x
36
Summary of Contents for SkyJiB X4 XL
